Highlights

1. The cigarette cutting system uses the double-knife single-cutting system with lower-rise temperature and lower noise. This gives the very good quality of the cigarette cut.

2. The complete suction system and high air pressure system .

3. The hopper system adopts AC servo motor to directly drive the tobacco cutting system. The timing belts are used instead of the gears, so the even tobacco-feeding is greatly improved and the maintenance cost is reduced as well.

4. It adopts AC servo driving system that simplifies the mechanical structures and reduces the failure and maintenance cost, and improves the transmission precision.

5. Electric control system:

◆ control center: it adopts the SIEMENS PLC S7-300 series.

◆ weight controller: the microwave weight control system is adopted to avoid any harm to people.

◆ man-machine interface: The SIEMENS touch screen provides friendly man-machine interface, which displays the machine status and production data precisely. It is also convenient to modify the system parameter and check out the failure.

Making Process Requirements:

1, Ambient conditions

Temperature: 20℃--30℃

Relative humidity: 62％--68％

2, Paper bobbin

Tensile strength ≥0.85KN/m

Extensibility ＞1.6％

Humidity: 6％±1.5％

Joint number ＜1/1000 m

3, Width: 48±0.3 mm

Thickness: 0.04mm～0.05 mm

4, Cut tobacco

Grade: A

Humidity: 12.5％±0.5％

5, 5.5bar

6, Viscosity of VPA

For the maker: 2500mPa.s-5000mPa.s

For the assembler: 5000mPa.s-10000mPa.s